Cleveland MKET-12-T Manuel du propriétaire télécharger pdf (Page 24)

Lubricants that should NEVER be used in the oil well of the reducer:

1. Motor Oil

2. Automotive Gear Oil

3. Grease

4. EP Oils

LUBRICATION INFO

Proper installation or your worm gear speed reducer is essential for efficient,

economical operation and a long operating life. The unit is built for proper

operation in the mounting position ordered. Tilted or different mounting

positions may require factory installed lubrication provisions.

Proper lubrication is crucial to obtaining the highest possible performance and

efficiency. All "A" series mixer drives are shipped from the factory WITHOUT oil.

Due to the nature of the worm gear's sliding and rolling actions, the lubricants

listed on the next page must be used.

INSTALLATION

OIL CHANGES

Check the oil level while the unit is not in operation. Add oil when the oil level

has gone below the fill line **Make sure to never mix oils. Drain and flush the

gear housing after the first 150 hours of operation.

The regular maintenance schedule should be as follows:

Drain the oil and flush after every 6 months of normal service (8 hours of

operation per day - 7 days per week, normal operating temperature).

Drain the oil and flush after every 3 months of heavy service (24 hours - 7

days per week) or (8 hours per day - 7 days per week in extreme

temperatures or extreme environments).

All input and output bearings used in Cleveland's "A" series mixers are factory

packed with NLGI grade 2 grease. This grease is mineral based with lithium

base thickener. Repack the bearings using the same grade of grease during all

normal oil change intervals.

GREASE LUBRICATED BEARINGS

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 62 63

Pas de commentaire

Cleveland MKET-12-T Manuel du propriétaire Page 24