Cleveland MKET-12-T Manuel du propriétaire télécharger pdf (Page 27)

LUBRICATION INFO - ALD SERIES

All units are shipped from the factory

WITHOUT oil. Units should be filled to

the level plug.

Check oil level periodically when the

unit is not operating. Add oil if

necessary. Drain and flush housing

after first 150 hours of operation.

Drain the oil and flush after every 6

months of normal service or after

every 3 months of heavy or severe

service (around the clock operation

or harsh operating environment). If

ambient temps are below 15° F, a

winter lubricant must be added since

AGMA 7 & 8 oils will solidify.

Suppliers of industrial lubricants

should be contacted to supply suitable

lubricants to meet AGMA

specifications (please see page 22

for oil recommendations)

Oil drain plug

Sight guage

Fill Line

(some units may have

several grease fittings

on both the reducer, motor

and stuffing box. Make

sure to grease all zerk

fittings on gear case.)

Grease fitting for low/high

speed bearings

Grease Lubricated Bearings - The low speed shaft bearings are provided with grease fittings. These

bearings are packed at assembly with a lithium base grease NLGI grade 2 with EP additives.

(Cleveland recommends Mobil or Shell - Durina SD2 / NLGI grade 2 bearing grease)

BEARING GREASE

GEAR CASE OIL

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 62 63

Pas de commentaire

Cleveland MKET-12-T Manuel du propriétaire Page 27